Autoscope IntelliSight User Guide
©2022 Image Sensing Systems Inc.
2-1
Chapter 2: Pre-Installation Considerations
General
This chapter provides information that should be considered prior to installing
the IntelliSight System hardware.
Required Tools
Tools that will be needed for installing the IntelliSight System hardware are:
•
Mounting bracket supplies including stainless steel banding
•
Din rail and screws for mounting
•
Screwdriver that accepts bits (bit provided with camera)
•
RJ-45 crimping tool
•
Screwdriver or drill to secure banding
•
Wire stripper
•
Knife or jacket stripper
•
Tie wraps for cable strain relief
•
Radios or cell phones to communicate between the cabinet and the
bucket truck
•
Computer and Ethernet network cable
•
Faceplate cleaning supplies (lint-free lens tissue/cloth and spray bottle
with water)
Cables
The following describes the various cables that are used with the IntelliSight
System.
Power Supply Connection
Power to the power supply must be 120/240VAC supplied from the traffic control
cabinet. Power to the power supply should be from the protected side of the
cabinet
Ethernet Cables
There are five Ethernet ports on the IntelliSight Processor. Each is an RJ-45
connector which uses a standard Ethernet cable (CAT 5, CAT 5E, or CAT 6). For a
