Autopilot Pool Pilot Digital Nano, Owners And Installation Manual, Page: 28 / 56

Page - 22
7.6.c Select Language
Allow for personal preference language display.
1. Press MENU, press
△
or
▽
until “Owner options” or “Installer menu” is displayed, then press
SELECT.
2. Press
△
or
▽
until “Select language” is displayed, then press SELECT (English is the factory
setting).
3. Press
△
or
▽
until desired option “English language” “Idioma Español,” “Langue Francaise,”
“Deutsche sprache”, “Lingua Italiana” or “Cesky Jazyk” is displayed, then press SELECT.
4. Press
△
or
▽
until “End menu mode” is displayed, then press SELECT.
7.6.d Calibrate Temperature
Note: You must wait a full two minutes after start up to calibrate temperature. Used only when it
is desired to match the display of the Digital Nano / Nano+ to another on-site thermometer.
1. Press MENU, press
△
or
▽
until “Maintenance menu” is displayed, then press SELECT.
2. Press
△
or
▽
until “Calibrate temp.” is displayed, then press SELECT.
3. Press
△
or
▽
to adjust temperature UP or DOWN to the desired temperature, then press SELECT.
The maximum adjustment is ± 6° F (± 3° C).
4. Press
△
or
▽
until “End menu mode” is displayed, then press SELECT.
7.6.e Select Units
Used to program the operator’s personal preferences for the liquid and weight measurements
the Digital Nano / Nano+ will display.
1. Press MENU, press
△
or
▽
until “Owner options” or “Installer menu” is displayed, then press
SELECT.
2. Press
△
or
▽
until “Select units” is displayed, then press SELECT (“English units” is the factory
setting).
3. Press
△
or
▽
until desired measurement “English units” (gallons and pounds), or “Metric units”
(liters and kilograms), is displayed and then press SELECT.
4. Press
△
or
▽
until “End menu mode” is displayed, then press SELECT.
7.6.f Set Temperature Unit
Set personal preference for temperature display units (°C or °F).
1. Press MENU, press
△
or
▽
until “Owner options” or “Installer menu” is displayed, then press
SELECT.
2. Press
△
or
▽
until “Temperature unit” is displayed, then press SELECT (Fahrenheit is the factory
setting).
3. Press
△
or
▽
until desired measurement unit “Fahrenheit” or “Celsius” is displayed, then press
SELECT.
4. Press
△
or
▽
until “End menu mode” is displayed, then press SELECT.