ADS-DSR1-CHR02B-AR
maestro.idatalink.com
RAM 1500 2013-2017
Automotive Data Solutions Inc. © 2019
3
INSTALLATION INSTRUCTIONS
STEP 1
• Remove the factory amplifi er (refer to wire chart for
amplifi er location).
• Confi gure the 2 pin connectors on the aCH2 T-harness as
shown on the wiring diagram.
STEP 2
• Connect the factory amplifi er harnesses to the aCH2
T-harness.
STEP 3
• Connect the wires from the aCH2 T-harness to the
aftermarket amplifi er.
Note 1:
If you are running your own speaker wires from the
amplifi er to the speakers, this step is not necessary.
Note 2:
The amplifi er output colors and labels on the aCH2
T-harness do not correspond to the vehicle. For vehicle
specifi c wiring designation, see the wiring chart.
• Plug the RCA cables in the aftermarket amplifi er.
STEP 4
• Connect all the harnesses to the DSR1 module.
CHIME ADJUSTMENT
This is only needed when the vehicle supports chimes (ex:
Parking assist, Blind spot detection, Lane sense, etc.).
• Set the audio source to OFF (if there is no way to turn the
radio OFF, set the source to AUX).
• The OEM radio will have 3 volume settings for parking
assist (Low/Med/High), it is recommended to choose
medium volume.
• Activate any chime (ex: rear parking assist).
• Adjust the chime volume using the volume knob.
• For technical assistance call 1-866-427-2999 or e-mail
“[email protected]”. Visit us at “maestro.idatalink.
com/support” and “www.12voltdata.com/forum/”
1
