DPM3-E Electrical User Manual, 1st Edition
User Manual - DPM3-E Series Electrical Panel Meters
7
Dimensions and Mounting
(2) Fixing clips
Sealing gasket
DPM3 Meter
Panel mounting surface
TRMS
Installation
To install the instrument, prepare a 92mm x 45mm panel cut-out and slide the unit inwards
making sure to place the sealing gasket between the front side panel and the front bezel.
While holding the unit in place, put the fixing clips on both sides of the case and slide them
through the guide tracks until they reach the panel at the rear side.
Press slightly to fasten the clips to the latching slots
on the case and get the unit fully assembled and close
fitted to achieve a good seal.
To remove the instrument from the panel, pull the
rear fixing clips latching tabs outwards until they are
disengaged, then slide the fixing clips back over the
case.
Installation
Dimensions
96 x 48 x 83.1mm (1/8 DIN)
Panel Cutout
92 x 45mm
(Max. panel thickness 10mm)
Case Material
Polycarbonate UL 94 V-0
