Troubleshooting the OP- 1212
34
D
If you are remapping, make sure that you are remapping in the proper
direction and that you are using a contact that is always ON as the input to
the remapping logic. Remapping must be performed every scan to function
properly.
Y12
C102
OUT
SP1
V2004
V40604
LD
OUT
Here we are using SP1 to map V2004 to V40604.
This consumes 16 relay bits, 12 of which are tied
to the 12 pushbuttons of the panel. By pressing
Pushbutton 3, you affect the status of the third
relay in V40604 which is C102. In turn, C102 will
control output Y12.
m+4 =V2004
remapping = V2004:40604
When I activate a bit to light a pushbutton LED, it does not light.
D
Verify that you are using the correct address. The base address you chose
during panel configuration determines the proper addresses to use.
D
If you are remapping, make sure that you are remapping in the proper
direction and that you are using a contact that is always ON as the input to
the remapping logic. Remapping must be performed every scan to function
properly.
D
Verify that
LED Separation Mode
was
enabled
during panel configuration.
When I press a pushbutton the associated LED does not turn ON.
D
If the LED Separation Mode was enabled, the LED will work independently of
the pushbutton. In this case the LED will be turned ON by the ladder logic
program.
D
The pushbutton may be configured as momentary. In this case the LED will
be ON only as long as the pushbutton is being pressed.
I can not make the lamp flash. What could I be doing wrong?
D
Remember that to flash a lamp, it must be turned ON first. Verify that you are
turning the Lamp ON before you activated the flashing option.
X13
Light Lamp 5
Add flashing
OUT
OUT
C4
C24
X14
3
4
Rungs 3 and 4 --Flashing Lamps
To flash a Lamp, it must be first turned ON. When
contact X13 is activated Lamp 5 will turn ON and when
contact X14 is activated the Lamp will flash.