AutomationDirect C-more EA9-T10CL, Hardware User Manual

Page: 71 / 140

Chapter 3 - Accessories
3-6
®
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
B
C
D
EA9-USER-M Hardware User Manual, 1st Ed. Rev. K
AC/DC Power Adapter Installation
WARNING: This procedure should only be performed by qualified personnel who are experienced in
working with electronic equipment. Take the necessary steps to prevent damage that may be caused by
static electricity discharge. Disconnect input power to the touch panel before proceeding.
Preparation: Place the touch panel face down on a lint-free soft
surface to prevent scratching the display screen if not already installed
in a control cabinet. Remove the DC power connector if it is installed.
1
Insert the AC/DC power adapter into the touch panel’s 5-position DC
power connector.
2
Secure the AC/DC Power Adapter to the touch panel by tightening the
two (2) spring loaded captive M3-20 screws to a torque of 50 oz-in
[0.35 Nm].
3 4
Plug the wired 3-pin AC Power Connector into its mating connector
on the adapter and secure in place by tightening the two (2) captive
M2.5 screws to a torque of 70 oz-in [0.5 Nm].