AutomationDirect C-more EA9-T10CL, Hardware User Manual

Page: 126 / 140

Chapter 5 - System Setup Screens
5-35
®
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
B
C
D
EA9-USER-M Hardware User Manual, 1st Ed. Rev. K
Project Executed from SD Card Slot 1
If the Project Storage/Boot Location is set to Auto or SD1 in the
C-more
software Panel
Manager, and an SD memory card is located in the SD Card Slot 1 at the time a project is
transferred to the panel, the project will be stored on the SD card, and the Internal Project
Memory will be cleared.
If Slot 1 contains an SD memory card with a project and the touch panel’s power is cycled,
then the project file stored on the SD card is loaded into the touch panel’s internal memory
and executed. Any project in the internal FLASH memory is cleared.
WARNING: During power up with an SD memory card plugged into an SD card slot, do not remove the
memory card from the slot. Damage to the SD memory card and possibly the touch panel may result.
WARNING: After a firmware update, the project files which are located in either the touch panel’s
internal FLASH memory or an SD memory card plugged into an SD card slot are cleared. The
programming software will need to be used to Transfer the project file back into the panel. If you wish
to retain the project on the SD memory card, power down the panel and remove the SD card before
performing a firmware upgrade.
Increasing Project Memory Size using an SD memory card:
If a project is transferred to the panel with an SD memory card in SD slot 1, the Font and
Recipe data files are not included in the 26 MB (82MB for 12” and 15” models) project size.
Therefore using an SD memory card can allow a project to be loaded that is larger than 26MB
IF the excessive size is caused by Fonts and/or Recipe Sheets.