Automationdirect.com Stellar SR44, User Manual

Page: 214 / 238

Appendix A: Setup Examples
A.2.2 – Changing the Parameter Group After the Unit Has Passed Top of Ramp
In this example the user is shown how to change parameter groups while running. This could be
useful, for example, if two overload values were required; one for starting and the other for
running.
1. With ‘Stopped and ready’ shown on the display, press the ENTER button once.
2. With ‘Applications’ shown on the top line of the display, press the
쑼
button until ‘Parameters’
is shown at the top of the display.
3. Press ENTER once to select the ‘Parameters’ menu.
4. With ‘P1 - P20’ shown on the display, press the
쑼
button until ‘P81 - P100’ is shown at the top
of the display.
5. Press ENTER to select ‘P81 - P100’.
6. With ‘P81 Kick Ped 2’ at the top of the display, press the
쑼
button until ‘P97 U1 I/P srce’ is
shown on the top line of the display.
7. Press ENTER to select ‘P97 U1 I/P srce’.
(continued next page)
Enter
#
Enter
#
1
2
3
4
5
6
#
#
29
29
29
7
(continued next page)
(press button multiple times, or hold to scroll)
(press button multiple times, or hold to scroll)
(press button multiple times,
or hold to scroll)
SR44 Series Soft Starter User Manual
1st Ed, Rev B 07/31/2019
A–20