Automationdirect.com Stellar SR44, User Manual

Page: 213 / 238

A–19
A.2 – Advanced Setup Examples
A.2.1 – Using an Alternative Parameter Group
For applications that require the control of two motors, or where the user requires different control
characteristics for a single motor at different stages of the duty cycle, the SR44 Soft Starter offers
two parameter groups. The Primary parameter group holds the parameters considered necessary
for motor starting and stopping, and it is this group to which the starter defaults. The Secondary
parameter group is a mirror of the parameters in the first parameter group, but NOT necessarily a
mirror of the values in the first parameter group. The parameters in each group are shown in Table
A.2.1.
The Primary group parameters can also be changed via the menu structure. However, the
Secondary group parameters can only be changed via the dedicated parameter numbers. As a
default, the Soft Starter uses the Primary group of parameters. The user can select either group
from the keypad or by using one of the programmable control inputs.
Table A.2.1 – Primary and Secondary Parameter Groups
Parameter Primary Group Secondary Group
Protection Mode P7 P78
Start Pedestal P11 P79
Start Time P12 P80
Kick Pedestal P13 P81
Kick Time P14 P82
Dwell Time P15 P83
Stop Pedestal P16 P84
Stop Time P17 P85
Auto Config P18 P86
Low Current Level P28 P87
Low Current Time P29 P88
Current Limit Level P30 P89
Current Limit Time P31 P90
Shearpin Level P32 P91
Shearpin Time P33 P92
Overload Level P34 P93
Overload Delay P35 P94
User Flags 1 P51 P95
User Flags 2 P52 P96
Appendix A: Setup Examples
SR44 Series Soft Starter User Manual
1st Ed, Rev B 07/31/2019