Automationdirect.com Stellar SR44, User Manual

Page: 208 / 238

Appendix A: Setup Examples
A.1.12 – Setting the Low Amps Level and
Using the K2 Relay to Display the Status of Low Current Bit
This example shows the user how to set the Low Amps Level, and how to monitor the status of the
Low Current bit via the K2 relay (see section 5.4.5).
1. With ‘Stopped and ready’ shown on the display, press the ENTER button.
2. With ‘Applications’ shown on the top line of the display, press the
쑼
button until ‘Advanced’ is
shown on the top line.
3. Press the ENTER button to select the ‘Advanced’ menu.
4. With ‘Current’ on the top line of the display, press ENTER to select the ‘Current’ menu.
5. With ‘Rated Current’ on the top line of the display, press the
쑼
button until ‘Low Amps Level’
is shown on the top line.
6. With ‘Low Amps Level’ on the top line of the display, press ENTER.
(continued next page)
Enter
#
Enter
#
#
#
1
2
3
4
5
6
23
(continued next page)
(press button multiple times, or hold to scroll)
(press button multiple times,
or hold to scroll)
SR44 Series Soft Starter User Manual
1st Ed, Rev B 07/31/2019
A–14