Automationdirect.com Stellar SR44, User Manual

Page: 196 / 238

A–2
1st Ed, Rev B 07/31/2019
SR44 Series Soft Starter User Manual
A.1 – Setup Examples
This section holds common programming examples that any customer might wish to use. They
explain how to set up the SR44 for common tasks. More advanced examples are given in section
A.2.
A.1.1 – How to Read the Setup Examples
Each example consists of numbered step-by-step instructions which take the user through every
action needed to complete the particular programming example. In addition, there are diagrams
which reference the text. The form these diagrams take are briefly explained below. (Note that the
actual instructions in the diagrams in this section, A.1.1, are for display only and are not intended
to make sense as instructions.)
If the unit needs to be ‘Disabled’ (see section A.1.2) before carrying out the instructions, the
example will say so in its introduction.
Enter
#
Enter
#
1
2
3
17
A circled number refers to the text for that
section at the line number given. In this
position, the circled number indicates that
instruction 1 is associated with the Enter
button, so the instruction will probably
read,” Press the Enter button.”
The arrow that is part
of the button icon
shows the direction of
diagram flow if that
button is pressed.
This is the screen that will be
displayed after instruction 2
has been completed and
before instruction 3 has been
started.
This is the screen that will be
displayed after instruction 3
has been completed.
A dotted arrow in this position,
i.e. pointing downwards, means
that the diagram continues on
the following page.
Instruction 3 is associated
with the Enter button at this
position.
The first diagram in every example
section will be the Stopped and Ready
screen or the Starter Disabled screen.
The box represents what will be seen
on the display before the action detailed
in line 1 has been performed. The box
to the right (showing Applications/Auto
Features )shows what will be displayed
after the action in line 1 has been
performed.
These icons represent
the buttons on the keypad
or remote keypad.
Refer to section 5.1.2 .
Press the Down Button
multiple times (or scroll)
until you reach the next
menu item as shown.
Appendix A: Setup Examples