Ethernet Communications Modules, 3rd Edition, Rev. D
7-9
Chapter 7: Maintenance and Troubleshooting
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
B
C
D
RX/WX Settings
The RX/WX Settings box in this window provides a place
to make changes that affect PLC-to-PLC communications
only.
Change these settings only if:
• The LINK/LINKGD LED is on.
• The ACT LED is flashing.
• You have explored the module configuration
and RLL programming for possible errors.
Record the Module Settings
If you are replacing an existing module, record the existing network identifier settings in the
Configuration box. Set up the replacement module by linking to it with NetEdit3 and inserting
the same network identifiers in the Configuration box. Click on Update Module to store the
settings in the ECOM module’s flash memory.
Each module on the network must have a unique network identifier.
