Automation Direct Stellar SR55 Series, User Manual

Page: 140 / 202

Page 5–14 Stellar
®
SR55 Series Soft Starter User Manual – 1st Ed, Rev F – 09/18/2019
Chapter 5: Communications
e
Ther
n
eT
/ip n
eTWork
C
ommuniCaTions
(
ConTinued
)
C
onneCTing To The
sr55-Cm-eneT m
odule Through
i/o (i
mpliCiT
m
essaging
)
The connection parameters for Connection 6 (Extended Control) are as follows:
• T->O (Input Data) Connection Point Assembly Instance value is 71
• T->O (Input Data) Size is 4 bytes
• The Data format for Status is shown in the “Input Data Setup” screen capture
• O->T (Output Data) Connection Point Assembly Instance value is 21
• O->T (Output Data) Size is 4 bytes
• The Data format for Control is shown in the “Output Data Setup” screen capture
• No Configuration data is required
To start the SR55, a value of 33 should be placed into Byte 0 of the Control data.
33 equates to Bit 0 (Run Forward) On and Bit 5 (Net Control) On.
To stop the SR55, a value of 32 should be placed into Byte 0 of the Control data.
32 equates to Bit 0 Off and Bit 5 On.
To reset faults on the SR55, a value of 36 should be placed into Byte 0 of the Control data.
36 equates to Bit 2 (Fault Reset) On and Bit 5 (Net Control) On.
The following images are an example setup of I/O (Implicit Messaging) to the SR55 EtherNet/IP
adapter from a Productivity Series CPU.
i
npuT
d
aTa
s
eTup