DPM1-P User Manual, 1st Edition
User Manual - DPM1-P Series Panel Meters
6
Dimensions and Mounting
Fixing clip
Sealing gasket
DPM1 Meter
Panel mounting surface
Dimensions mm [in]
Installation
To install the meter, prepare a 45mm x 22mm panel cut-out and slide the unit inwards making
sure to place the sealing gasket between the front side
panel and the front bezel.
While holding the unit in place, put the fixing clip
around the case and slide it until it reaches the panel
at the rear side.
Press slightly to fasten the clips to the latching slots
on the case and get the unit fully assembled and close
fitted to achieve a good seal.
To remove the meter from the panel, pull the rear fixing clips latching tabs outwards until they
are disengaged, then slide the fixing clips back over the case.
Installation
Dimensions
48 x 24 x 125.1mm (1/32 DIN)
Panel Cutout
45 x 22mm
(Max. panel thickness 7mm)
Case Material
Polycarbonate UL 94 V-0
