Do-more H2 Series PLC User Manual, 1st Edition, Rev. F - H2-DM-M
6–59
Chapter 6: Specifications - Analog I/O Modules
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
B
C
D
F2-8AD4DA-2 Analog Input/Output - continued
Input Configuration Using Do-more Designer Version 1.1 or Newer
Using the Module Configurations section of the Do-more Designer System Configuration,
each of the eight input channels can be individually configured for resolutions: 12, 14, or 16
bit, configured for track and hold options: None (no hold), Minimum, Maximum, or Reset
held value, or each input can be individually disabled. Input and output ranges can also be
configured for 0 to 5V or 0 to 10V in this section.
From the System Configurations page, select Module Configuration(s) in the tab on the left.
The screen below will appear showing the modules that are pre-configurable. Select the Type
F2-8AD4DA-x in the table and click the Edit Config button on the right-hand side.
Once the Edit Config button is selected, the Module Settings page shown below will open.
From this page each input channel can be configured with Resolution and/or Track and Hold
options. Input/output range options are also available. Select the radial button next to the
desired options and select the OK button when done.
