p.
4/24
The information contained in this document is the property of Automatic Systems and is confidential. The recipient shall refrain from using this information for any purpose other than the
use of the products or the execution of the project to which it refers and from communicating it to third parties without prior written agreement of Automatic Systems. The document is
subject to change without notice.
CL 636-MT-EN
1. SAFETY WARNINGS.
•
This manual must be made available to any person who works with the equipment, e.g., installers, maintenance technicians,
end users, etc.
•
This equipment has been designed to control and manage pedestrian access and flow and cannot be applied to any other
use without risk to users or to the integrity of the equipment.
Automatic
Systems
cannot be held responsible for damages
caused by improper use of the equipment.
•
It is strongly recommended that children be supervised as they pass through the door. Extreme care is also required with
animals, which should be kept on a leash and under the control of their owners.
•
Do not add non-approved accessories (contact between different metals causes an electrolytic effect that decreases the
equipment’s corrosion resistance or a malfunction of the metal detector).
•
The Contractor shall comply with local standards when installing the equipment.
•
Any work on the equipment must be performed by qualified personnel.
Automatic
Systems
shall reserve the full right to
automatically refuse our warranty if any unauthorized work or work performed by an unqualified technician is performed on
this product.
•
Access to the mechanism is reserved for personnel who are aware of the electrical and mechanical dangers in the case of
negligent operation. This personnel is obliged to close off access to the mechanical equipment after completing any work.
•
For any operation that does not require the equipment to be powered on, disconnect the electrical power using the SYSTEM
switch on the console ð OFF (or open the breaker on the client distribution panel) AND disconnect the batteries.
•
Any internal element that may be live or that could move should be handled with caution.
•
The equipment is factory configured in «minimal risk» mode for its users. Parameters should only be changed by qualified
personnel with full knowledge of the consequences, and this shall in no way entail any liability on the part of
Automatic
Systems
.
•
The equipment must be completely visible to the user/operator before being put into operation.
•
After a collision, even if there is no visible damage, the equipment must be checked by a qualified technician.
