USER GUIDE AND INSTALLATION MANUAL
SB3PRxx 3-POINT RETRACTABLE LAP BELT
IMPORTANT:
1. For lap seat belts, mounting hardware to the floor should always have metal-to- metal contact. You
should avoid carpet, plastic or any other material between the lap seat belt fastener components and
the floor which could tend to loosen over time.
2. All bolts must have either a lock-nut, lock washer or apply a thread locking compound for security.
3. Bolts used for mounting seatbelts should be a minimum size 7/16" diameter, Grade 5 product.
4. Anchor points for belts must meet the strength load requirements of FMVSS 210. When replacing
belts, always use the anchorages provided by the vehicle, or seat manufacturer.
5. Do not connect both ends of this belt to the same, single mounting point. Mounted ends of the belt
should form a "U" shape.
Seatbelt Anchor
Plate
Figure 4.
Mounting Seat Belt
Anchors to the Floor
*Note- if your vehicle does not
have a shoulder anchor point,
see figure 5.
90°
