Autodesk HP xw9400, Hardware Setup Manual

Page: 39 / 54

Comment Menu Item Menu
3 is the recommended setting Clip Detect: 3 Meter
8 is the recommended setting Route Unit: 8 SystemMiscellany
Lucid ADA 88192 Converter Settings for Local Control
You must configure the following settings to control the converter locally. Any setting not listed here either
has no effect with the application or can be set to any of the values available for it.
Comment Menu Item Menu
ADAT INs: SRC ONADAT INs: SMUX
OFF ADAT
AES IN1+2: SRC OFF
AES IN3+4: SRC OFF
AES IN5+6: SRC OFF
AES IN7+8: SRC OFF AES
IN1+2: SoftClip ON
IN3+4: SoftClip ON
IN5+6: SoftClip ON
IN7+8: SoftClip ON Analog
Analog INs: SoftClip
set each input channel to a value in
the range -95.5 to +31.5 dB Analog
Analog INs: Gain
set either -10 or +4 for each output
channel Analog
Analog OUTs: Level
3 is the recommended setting Clip Detect: 3 Meter
If these options do not appear, verify that Route Unit
(in the System, Miscellany menu) is set to 8. For analog audio:
AES INs --> ADAT OUTs
Analog INs --> AES OUTs
AES INs --> Analog OUTs Route
For digital audio:
AES INs --> ADAT OUTs
AES INs --> AES OUTs
AES INs --> ANALOG OUT
External AES 1+2 is the recommended setting. Internal OFF
External AES 1+2 Sync
Route Unit: 8 System
Miscellany
Audio Keywords in the Software Initialisation
Configuration File
There are two keywords in the software initialisation file (by default, init.cfg ) that must be uncommented
and set to the correct values to ensure Discreet Native Audio works properly. The first, Audiodevice, enables
Lucid ADA 88192 Converter Settings for Local Control | 33