Autodesk CP100, User Manual

Page: 69 / 80

Modifying the Hue, Saturation, and Lightness Curves
63
Modifying the Hue, Saturation, and Lightness Curves
You can modify the hue, saturation, and lightness curves that appear in the Curves menu. You
can modify the entire curve uniformly or modify individual vertices for RGBCMY channels
(red, green, blue, cyan, magenta, and yellow). You must toggle between controls that modify the
position of the red, green, and blue vertices and those that modify the position of the cyan,
magenta, and yellow vertices.
To modify hue, saturation, and lightness curves:
1. Enable HueCrv to access controls for the red, green, and blue vertices.
2.
Use the following controls to modify the hue, saturation, and lightness curve at each
displayed vertex.
3.
Press HueCrv again to access controls for the cyan, magenta, and yellow vertices, and then
modify the curves.
Secondary Colour Grading
You can colour grade up to eight secondaries from the control surface.
=====
Prmry |PanScn|Curves|HueCrv|Keyer| Geom
=====
InPr | Sec1 | OutPr | Reset |Inside| Outside
Hue Curves
Red Hue | Red Lig | Red Sat
Hue Curves
Green Hue | Green Lig | Green Sat
Hue Curves
Blue Hue | Blue Lig | Blue Sat
Hue Curves
Master Hue | Master Lig | Master Sat