Auto openers SO-1000F, Instruction Manual

Page: 9 / 18

To view our how to install video visit:
www.autoopeners.com.au
Door Travel / Limit Settings
1. Travel limit setting
Press the ‘SET’ button and hold on until the LED displays figure ‘1’ ; then adjust the
up limit by pressing ‘up’ button. Fine-tuning ‘up’ or ‘down’ button to determine
the final up limit position then press t h e ‘set’ button. T he display will now
change to ‘2’ . Adjust the down limit by pressing t h e ‘down’ button. Y o u c a n f ine
tune by pressing the ‘ up’ or ‘down’ buttons to determine the final down limit
position and then pressing the ‘set’ button. The opener will operate a cycle
automatically to remember the limit positions and the opening & closing force.
2. Coding the Remotes into the Motor
Fig. B
3. Safety reverse force adjustment
Press t h e ‘SET’ button and hold on until the LED displays ‘3’. This will enable the
force adjustment mode. Press t h e ‘UP’ button to increase the force and ‘DOWN’
button to decrease the force. The maximum force is 9 and the minimum is 1.
Press the ‘SET’ button to confirm. It is strongly recommended you test the force
setting with a block of wood on the floor to ensure that the safety reverse function
is operating as designed. This test must be performed monthly to avoid entrapment
of animals or children.
Press and hold the ‘Code’ button until the red LED light displays in the
bottom right corner of the screen. Press any button on the transmitter
once and the LED will go out. Press the same button on the remote
control, the LE
D will display ‘11’ as the dot flashes rapidly. Your
transmitter has been coded in.
To Delete A Transmitter
Press and hold the ‘ Code ’ button for 8 seconds or until the display shows
‘ C ’ . All stored codes will be deleted.