Auto openers SO-1000F, Instruction Manual

Page: 10 / 18

To view our how to install video visit:
www.autoopeners.com.au
4. Auto-close setting (Optional)
5
．
Photo beam setting (Optional)
6. Operate Terminal
Press the ‘UP’ button and hold on until the LED displays
‘ - ’. E v e r y t i m e y o u p ress t h e ‘ UP ’ button, the
auto-close time will increase by 1 minute, the
maximum time is 9 minutes.
By pressing the ‘down’
button. the auto-close time will decrease by 1 minute.
The auto-close function will be turned off when LED
displays 0. Press the
‘SET’ button to confirm.
Please note, your Photo Beams must be installed and lined
up correctly before proceeding.
Press t h e
‘DOWN’ button and hold on until the LED
displays ’11’, then press ‘UP’ button u n t i l the LED
displays ‘H’ . The photo beam function is now available.
Press the ‘DOWN’ button u n t i l the LED displays ‘11’ to
cancel this function. When setting is finished, press ‘SET’
to confirm. When connecting
pulsed quantity control
infrared sensor, wiring as p e r Fig.12. When infrared sensor
is controlled by switch value, wiring as per Fig.13.
Notice:
Disable the photo beam function when you don’t use photo
beam sensor.
Connecting a switch to this terminal, you can use the
switch when maintaining or the transmitter is left in
garage(Fig.12).