Please turn off the aircraft correctly, otherwise the camera parameters would not be saved
and the video being recorded would be damaged. Autel Robotics will assume no
responsibility for the loss caused by failure to read video or photo.
It is recommended to limit the single recording time within 30 minutes to ensure camera
system stability.
Please check camera parameter setting and ensure accurate parameters before shooting.
Before the important video is shot, please conduct the several test shootings to ensure
that the equipment is normal.
The photo or video stored in Micro SD card can be downloaded through Autel Sky App
only when the aircraft is turned on.
2.5 Propeller
Warning
Please turn off the aircraft power switch before installing or dismantling the propeller.
Important
It is necessary to wear protective gloves when installing or dismantling the propeller.
2.5.1 Install propeller
1. Confirm that the aircraft has been turned off.
2. Select the propeller matching the boom.
3. Align the round hole of the screw propeller with
the screw hole of the motor and lock the screw.
Propeller
Dot mark
Without dot mark
Schematic diagram
Matching arm
Install to boom with dot
Install on the arm without dots