12
Characters used to help navigate the scan tool are:
1)
“
#
” – Identifies the control module number from which data is
retrieved.
2)
“
Pd
”
– Identifies a pending DTC when viewing DTCs.
3.5
Keyboard
No solvents such as alcohol are allowed to clean the keypad or display.
Use a mild nonabrasive detergent and a soft cotton cloth. Do not soak
the keypad as the keypad is not waterproof.
3.6
Power
The scan tool is powered via the vehicle Data
Link Connector (DLC).
Just follow the steps below to turn on the scan tool:
1)
Locate DLC on vehicle.
A plastic DLC cover may be found for some vehicles and you
need to remove it before plugging the OBD II cable.
2)
Plug the tool’s OBD II cable to the vehicle’s DLC.
3.7
System Setup
The scan tool allows you to make the following adjustments and
settings:
1)
Language
:
Selects the desired language.
2)
Configure Monitors
: Sets the monitors you want to test.
3)
Unit of Measure
: Sets the unit of measure to English or Metric.
4)
Key Beep Set
: Turns on/off key-press beep.
5)
Status Beep Set
:
Turns on/off the I/M Readiness Status beep.
6)
Tool Self-test
: Checks if the LCD display, LED lamps and
keyboard are working normally.
7)
Update Mode
:
Accesses the Update Mode.
Settings of the unit will remain until change to the existing
settings is made.
To Enter the Setup Menu
