Autel Robotics EVO II Pro Enterprise, User Manual

Page: 54 / 64

54
Chapter 6
Annex
6.1 Authentication information and restricted area
6.1.1 Authentication information

FCC Warning Message
Any Changes or modifications not expressly Approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference
(2) this device must accept any interference received, including interference that
may cause undesired operation.

FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body. This transmitter must
not be co-located or operating in conjunction with any other antenna or transmitter.
For EVO
Ⅱ
Enterprise with model EF7, SAR tests are conducted using standard operating
positions accepted by the FCC/ISEDC with the device. When used, please keep the distance
with a minimum of 10mm from the body.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.

ISEDC RSS Warning
This device complies with ISEDC licence-exempt RSS standard (s). Operation is subject to the
following two conditions: