PLEASE TURN PAGE FOR INSTALLATION STEPS 5 - 8
(Pk0024) YV Instructions- YV Standard Outer Pull (Trade A4) R5.cdr
Install the Keyed Cylinder into the Outer Pull
Several pairs of Fixing Screws are provided to suit different door
thicknesses. Use the table below to identify which are the correct
length Fixing Screws.
NOTE:
If using packer(s), add the total packing thickness to the door
thickness, then use this value in the table below.
Figure E
27.5 to 21.3mm
33.8 to 27.6mm
40.1 to 33.9mm
46.4 to 40.2mm
Interior
14.0 mm
41.0 mm
41.0 mm
Door Stile
Exterior
Door Jamb
Mark
Door Stile
9.0 mm
Mark and measure
from this edge
Figure A
For optimal installation, ensure the door is rolling smoothly and closing
parallel into the jamb by lubricating and adjusting the rollers. Close the
door and lightly mark the door stile at the edge of the overlapping jamb.
Prepare three 9.0mm holes in the door stile as dimensioned below in
Figure A. Ensure the holes are straight and free from burrs.
E TH
L
C
IS
Y
P
C
A
E
C
R
K
E
A
S
G
A
IN
E
G
L
P
If a cylinder is not being used in the Outer Pull, proceed to STEP4.
Use the table in Figure C below to determine the required Spindle length.
NOTE:
If using packer(s), add the total packing thickness to the door
thickness, then use this value in the table below.
To remove a Cylinder Plug and install a Keyed Cylinder into the Outer Pull,
remove the Retaining Plate and remove the Cylinder Plug. (refer Figure B)
The Cylinder Plug can be discarded.
Use pliers or a vice to carefully break off the required number of pre-notched
portions of the Spindle to suit the door thickness.
Illustrated fitting instructions
Illustrated Fitting Instructions for Yarra Deadlock using:
YARRA DEADLOCK SERIES
YARRA VIEW
STANDARD OUTER PULL
Austral
Lock
These instructions describe the steps to install a Yarra View (or Yarra Ridge)
deadlock with a Yarra View Standard Outer Pull. Read through all instruction
steps before beginning installation. When replacing an old lock, modify the
existing installation holes in the door stile and jamb if necessary.
Total Width
(Door thi Packer thickness)
27.5 to 21.3mm
33.8 to 27.6mm
40.1 to 33.9mm
46.4 to 40.2mm
Spindle preparation
Break off ‘3’ portions
Break off ‘2’ portions
Break off ‘1’ portion
Break off ‘0’ portions
Retaining Plate
Cylinder Plug
Outer Pull
Figure B
Figure C
Discard
Notch
Spindle
Insert the Spindle through the hole in the Retaining plate, and re-assemble
the Retaining Plate into the Outer Pull. It may be necessary to rotate the
Spindle to find its position between the Drive Pins on the Cylinder.
Push the Retaining Plate in firmly so it will not come loose while assembling
the Outer Pull onto the door.
Keyed Cylinder
Screw selection
Total Width
(Door thi Packer thickness)
1” Fixing Screw
1 ¼” Fixing Screw
1 ½” Fixing Screw
1 ¾” Fixing Screw
Retaining Plate
Outer Pull
Spindle
Cylinder Drive Pins
Figure D
