C200H-HI / C200H x4 / C250H-HI
C250HI LE / C250H x4 / C250H x4 LE
84
Engine oil: Filling up
- Remove the dipstick
(b)
and place a funnel in the opening of the oil filler neck
located above the rocker arm cover.
- Fill the engine to the recommended oil level. See the
TABLE OF FLUIDS AND
LUBRICANTS
(references and capacities) in this Operator’s manual for oil type
and capacity.
- Start the engine and leave idling for a few minutes. Check the areas around the
oil filter and oil drain plug for leaks.
- Switch off the engine.
Wait a few seconds to allow the oil to flow towards the engine oil pan and then
check the level.
- Top up if necessary.
CAUTION
Do not exceed the maximum level mark. Starting the engine with incorrect oil
levels may cause serious damage. Clean up any spillage. Check the oil level
often and top up where necessary.
Dispose of used oil in authorized centres.
Coolant
system
Level of coolant: Checking
WARNING
Never remove the coolant reservoir cap while the engine is hot. Wait until the
engine has cooled down.
The level of coolant should be between the “MIN” and “MAX” marks on the coolant
reservoir
(fig. 2)
.
If the coolant level is below the “MIN” mark, top up the coolant reservoir with coolant.
Check the engine, hoses and radiator for possible coolant leaks.
(fig. 4 – K
U
B
O
TA
V2403-M)
(fig. 3 - ISUZU 4LE2)
(fig. 2 – K
U
B
O
TA
V2403-M)
(fig. 1 - ISUZU 4LE2)
b
b
FULL
LOW
FULL
LOW
Periodic
Maintenance
Operations