TECHNICAL SPECIFICATIONS
Voltage
: 230 VAC
Frequency
: 50-60 Hz
Power
: 7 kW
Operatable min. water pressure
: 2.5 mSS
Inlet Controlled Pressure
: 0 Pa (model 105MC...)
Outlet Controlled Pressure : 600 kPa (model 105MC..C)
Min. Operating Pressure
: 25 kPa (2.5 mSS)
Max. Operating Pressure
: 600 kPa (61 mSS)
Flow rate
: 100-240 L/hour
Size (H, W, D)
: 330x210x110 mm
Net Weight:
: 2 kg
Protection Class
: l
Zmax
: 0.21 + j 0.13 Ώ
Protection aganist moisture : IP44
MODEL
105 MC...
105MC..C
USER MANUAL
Dear Customer,
Thank you for choosing our product. We hope that
microControl Water Heater, which has been manufac-
tured in modern facilities in pursuant to high-quality
standards, will provide the best efficiency for you.
Therefore, please read the entire user manual thorough-
ly and keep it for future reference.
WARNING!
The water inlet of this appliance shall not be connected
to inlet water obtained from any other water heating
system.
This appliance is not to be used for a potable water
supply.
INTRODUCTION OF WATER HEATER
• It is under the consumer's own responsibili-
ty to suit electrical and water installation to
the water heater.
• For your appliance with 7 KW heating power
being able to be mounted, have its necessary
electrical and water installation made by
qualified electricians and plumbers.
• The electrical connection of the device
should be grounded. It should never be used
in buildings which do not have an earth, have
an inadequate earth or an earth which fails to
comply the rules. Otherwise, our company
shall not be responsible from problems to be
occurred.
• Your appliance is only for household use. It
should not be used for commercial or
industrial purposes (at hairdressers which
require continuous hot water, and workplaces
such as construction sites, small scale
workshops etc.).
• Your appliance can not be connected to
main water supply in the flat, should be
connected to where authorized service
deems suitable.
•
Authorized Service only makes the
electrical connection of the appliance to the
completed installation, and its initial starting.
• Do not mount your water heater where the
water in its inside may freeze. In case the
water freezes, do not operate your appliance.
• The appliance should be connected to
minimum 32 Ampere-Automatic fuse.
• When your appliance is operating, do not
operate other devices which have more than 1
KW power (oven, iron, washing machine,
dishwasher etc.).
• Only use the hose and fittings given with the
appliance when installing. Do not use
pre-used hose or fittings.
• Always contact with Authorized Service for
all kind of malfunctions, maintenance and
spare part procurement.
• In places where the water pressure is more
than 6 bars, it is recommended to insert a
pressure reducer regulator to cold water inlet
of your water heater. The hoses or pipes
which shall be directly connected to the
installation should be resistant to 6 bar
operating pressure.
• According to the season's temperature, inlet
water temperatures will vary. You may supply
hot water as you wish by adjusting the water
temperature selection stepping switch and
water inlet amount.
• Power supply of the water heater is
deactivated in case of inadequate pressure or
water cut. When it reaches the adequate
pressure, power supply is activated again.
• This appliance can be used by children form
8 years and above and people with reduced
physical, sensory or mental capabilities or
lack of experience and knowledge if they
have been given supervision or instruction
concerning the use of the appliance in a safe
way and understand the hazards involved.
Children must not play with the appliance.
Cleaning and maintenance by the user must
not be performed by children, unless they are
over 8 years old and supervised. Keep the
appliance and its cord out of reach of children
aged less than 8 years.
• This device must be mounted vertically.
• Power selector should be at “0” position
when the appliance is not used.
IMPORTANT WARNINGS
1. Front Casing
2. Power selector switch
3. Shower head
4. Adjistable holder
5. Fixed holder
6. Outlet hose
7. Tap
8. Inler hose
9. Lock nut
10. Rear casing
11. Mounting Holes
Instant Water Heater
