Electric shock due to presence of hazardous voltage!
Death or serious injury.
→
Disconnect device from the mains before opening.
→
Wait for 60 seconds after power cut-off prior to opening the housing.
1.
Loosen screws [2] and remove cover [1].
2.
Insert cable glands [5].
➥
The enclosure protection IP… stated on the name plate is only ensured if suit-
able cable glands are used.
Figure 12: Example: Name plate for enclosure protection IP68
3.
Tighten cable glands and blanking plugs with the appropriate torque in compli-
ance with the manufacturer's specifications.
6.3.
Cable connection
Cable arrangement
The shown cable arrangement is only applicable for actuators with I/O interface!
For actuators with fieldbus interface, please refer to appropriate short instructions
(if available).
Cable arrangement depends on the number of cables connected in addition to the
mains cable. There are two options:
Figure 13: Cable arrangement
[1]
Cable arrangement for one mains cable and one signal cable
[2]
Cable arrangement for one mains cable and two additional cables
For better accessibility, we recommend heeding the following order.
1.
Insert signal cable into cable gland on the right and push upward until the cable
is visible.
18
PF-Q80 – PF-Q600
Electrical connection
