9.8.1
Running direction CLOSE (black section): set
1.
Move valve in direction CLOSE to desired intermediate position.
2.
If you override the tripping point inadvertently: Turn valve in opposite direction
and approach intermediate position again in direction CLOSE.
Information: Always approach the intermediate position in the same direction
as in later electrical operation.
3.
Press down and turn setting spindle [1] with screw driver in direction of the
arrow and observe the pointer [2]: While a ratchet click is felt and heard, the
pointer [2] moves 90° every time.
4.
If the pointer [2] is 90° from mark [3]: Continue turning slowly.
5.
If the pointer [2] moves to mark [3]: Stop turning and release setting spindle.
➥
The intermediate position setting in running direction CLOSE is complete.
6.
If you override the tripping point inadvertently (ratchet click is heard after the
pointer has snapped): Continue turning the setting spindle in the same direction
and repeat setting process.
9.8.2
Running direction OPEN (white section): set
1.
Move valve in direction OPEN to desired intermediate position.
2.
If you override the tripping point inadvertently: Move valve in opposite direction
and approach intermediate position again in direction OPEN (always approach
the intermediate position in the same direction as in later electrical operation).
3.
Press down and turn setting spindle [4] with screw driver in direction of the
arrow and observe the pointer [5]: While a ratchet click is felt and heard, the
pointer [5] moves 90° every time.
4.
If the pointer [5] is 90° from mark [6]: Continue turning slowly.
5.
If the pointer [5] moves to mark [6]: Stop turning and release setting spindle.
➥
The intermediate position setting in running direction OPEN is complete.
6.
If you override the tripping point inadvertently (ratchet click is heard after the
pointer has snapped): Continue turning the setting spindle in the same direction
and repeat setting process.
9.9
Test run
Perform test run only once all settings previously described have been performed.
9.9.1
Direction of rotation: check
1.
Move actuator manually to intermediate position or to sufficient distance from
end position.
52
SGExC 05.1 – SGExC 12.1 Control unit: electromechanic
Commissioning (basic settings)
ACExC 01.2 Intrusive Modbus RTU