AUMA ACE C 01.2 Profinet Series, Manual

Page: 57 / 112

Not ready REMOTE (S0006)
The S0006 display shows indications of the Not ready REMOTE group.
If such an indication has occurred, the display shows S0006 :
●
the number of indications occurred
●
a blinking crossbar after approx. 3 seconds
Figure 66: Not ready REMOTE indications
For further information, please also refer to <Corrective action>.
Fault (S0007)
If a fault has occurred, the display shows
S0007
:
●
the number of faults occurred
●
a blinking exclamation mark after approx. 3 seconds
Figure 67: Fault
For further information, please also refer to <Corrective action>.
8.2.3. Status indications according to NAMUR recommendation
These indications are available, if the parameter Diagnostic classific. M0539 is set
to NAMUR .
Out of Specification (S0008)
The S0008 indication shows out of specification indications according to NAMUR
recommendation NE 107.
If such an indication has occurred, the display shows S0008 :
●
the number of indications occurred
●
a blinking triangle with question mark after approx. 3 seconds
Figure 68: Out of specification
For further information, please also refer to <Corrective action>.
Function check (S0009)
The S0009 indication shows function check indications according to NAMUR
recommendation NE 107.
If an indication has occurred via the function check, the display shows S0009 :
●
the number of indications occurred
●
a blinking triangle with a spanner after approx. 3 seconds
57
SAEx 07.2 – SAEx 16.2/SAREx 07.2 – SAREx 16.2 Control unit: electronic (MWG)
ACExC 01.2 Non-Intrusive HART
Indications