Torque (S0002)
The indication is only available if the actuator is equipped with an MWG (magnetic
limit and torque transmitter).
●
S0002
on the display indicates the torque applied at the actuator output.
●
The bar graph display appears after approx. 3 seconds.
Figure 69: Torque
Select unit
The push button allows to select the unit displayed (percent
%
, Newton metre
Nm
or "foot-pound"
ft-lb
Figure 70: Units of torque
Display in percent
100 % indication equals the max. torque indicated on the name plate of the actuator.
Example: SA 07.6 with 20 – 60 Nm.
●
100 % corresponds to 60 Nm of nominal torque.
●
50 % corresponds to 30 Nm of nominal torque.
Operation commands (S0003)
The display
S0003
indicates:
●
active operation commands, like e.g.: Operation in direction CLOSE or in direc-
tion OPEN
●
the actual value E2 as bar graph indication and as value between 0 and 100
%.
●
for setpoint control (positioner): setpoint E1
●
for stepping mode or for intermediate positions with operation profile: pivot
points and operation behaviour of pivot points
The navigation support (bottom row) is faded out after approx. 3 seconds and the
axis/axes for pivot point display are shown.
OPEN - CLOSE control
Active operation commands (OPEN, CLOSE, ...) are shown above the bar graph
display. The figure below shows the operation command in direction CLOSE.
Figure 71: Display for OPEN - CLOSE control
E2
Actual position value
58
SAEx 25.1 – SAEx 40.1 / SAREx 25.1 – SAREx 30.1
Indications
ACExC 01.2
