23
Device Pairing
Automatic Pairing
The system automatically scans and pairs to the Aulisa sensor module(s) from the
same starter kit only when the connection between the Display Unit and the
Receiver/Transponder has been established first.
Pairing with a new Aulisa sensor module
Follow the below instructions to manually set up the pairing of a new Aulisa sensor
module.
Step 1:
Ensure the designated Aulisa sensor module(s) is turned on.
Step 2:
In the Setting menu, select “PAIRING"
→
“SENSOR MODULE”.
Step 3:
Scan the QR Code or key in the serial number located on the Aulisa sensor
module(s).
Step 4:
Press “CONFIRM” if the serial number (SN) displayed matches with the one
on the Aulisa sensor module(s).
Step 5:
To confirm that the process was successful, ensure that the Bluetooth
connection status icon on the MAIN screen of the Display Unit is lit blue.
NOTE:
The Aulisa sensor module(s) must be placed within 32.8 feet (10 meters) to the
Receiver/Transponder.
NOTE:
The Bluetooth connection status icon will turn blue once the pairing succeeds.
NOTE:
The power LED on the Aulisa sensor module(s) will blink green when pairing
succeeds, and data transmission starts.
NOTE:
Up to four (4) Oximeter Modules and two (2) Thermometer Modules can be
stored on the Display Unit.
NOTE:
The Aulisa sensor module(s) must be placed within 32.8 feet (10 meters) to the
Receiver/Transponder.
NOTE:
The power LED on the Aulisa sensor module(s) lights green when the power is
ON.
Summary of Contents for Guardian Angel GA2000 Series
Page 5: ...4 Guide to Symbols...
Page 6: ...5...
