User Manual smar-tel-i
71
Progr
am
mi
ng
The following chapter describes a few new operating and programming functions for your
AUERSWALD PBX (ETS-4308 I or ETS-2204 I), which you can use if you operate one or
more smar-tel-i’s as system telephones on the internal S
0
bus.
The smar-tel-i system telephone is equipped with an InterCom function.
This means that you can call a smar-tel-i from any extension phone of your AUERSWALD
PBX and make an announcement in that room without the necessity of someone in the room
actively accepting the call.
In addition to activating the speaker, smar-tel-i can also activate the microphone (hands-off
telephoning), so that anyone in the vicinity can converse with you over the InterCom con-
nection.
In order to operate the InterCom function on your system telephone, it must be authorized
by the extension in question (refer to the following chapter).
Call a system telephone and use it for an announcement or to telephone hands-free:
h
An announcement or hands-free telephoning is limited to 120 seconds. Then the con-
nection is automatically terminated.
If your smar-tel-i is called with the InterCom function, the middle LED blinks and the
display shows “InterCom“ and the subscriber who is calling. After one ring, smar-tel-i
accepts the call automatically. By pressing the soft-key under “OK“ or by picking up the
receiver, you can initiate a normal call.
If you would like to use the smar-tel-i InterCom function described in the previous chapter,
it must be enabled for the respective extension.
Enabling / Disabling InterCom on a system telephone:
5. 14
New AUERSWALD PBX Functions
5. 14. 1
System Telephone Speaker-Phones and Announcements (InterCom)
b
49
n
f
g
for an announcement
extension number (e. g. 41)
dial
tones
for speaking in a room.
or
39
for hands-off telephon-
ing
5. 14. 2
Enabling / Disabling InterCom
b
7
Q
110
S
the designated
phone
public password
1: enable / 0: disable
