56
User Manual smar-tel-i
Progr
am
ming
If you have requested from your provider the ISDN services and functions described in the
following sections and if they have been enabled, you can decide in each case if you would
like to use any given service with your smar-tel-i.
If you do not want to be disturbed by incoming calls, this function can deactivate call-waiting
on your smar-tel-i. In the factory default setting, Call-Waiting is enabled (refer to the chapter
You Have a Call-Waiting Signal on page 25).
Example: Disabling Call-Waiting (deactivating).
h
The performance feature “Call-Waiting“ (CW) must be requested from and activated
by your provider.
In order to function, Call-Waiting must also be enabled in the Auerswald PBX.
Since as a rule switching a call is not possible with a direct connection to the network termi-
nal (i.e. operating without a PBX), switching a call in smar-tel-i is disabled in this operative
configuration. After replacing the receiver during a consultation call, you will hear short,
sequential rings for a period of eight seconds. smar-tel-i is signaling that a subscriber is still
waiting on hold. Please pick-up the receiver. You are then connected again with the caller
and the call can be terminated as usual.
If you connect your smar-tel-i to a PBX, then switching a call with this function can be acti-
vated. (Please follow the instructions of the PBX user manual).
5. 8
Enabling / Disabling ISDN Functions
5. 8. 1
Activating / Deactivating Call-Waiting
Search for the function under the menu-group
USEFUL
APPLICATIONS
change
A
Open the menu.
off
A
Deactivate Call-Waiting.
ok
A
Store the setting.
5. 8. 2
Enabling / Disabling the Exchange
Call Waiting ALLOW
change next
Call Waiting ALLOW
ok off
Call Waiting OFF
ok allow
