36
User Manual smar-tel-i
Progr
am
ming
In order to enter the public telephone network when operating a PBX, an exchange access
code (for example a “0“) must be dialed before the telephone number. By using the following
smar-tel-i function, smar-tel-i automatically executes an exchange line access when the
receiver is picked-up if you enter the digits (a maximum of 3) that are required for an
exchange line access on your PBX (refer to your PBX user manual).
Example: Install “0“ as an exchange line access code .
h
If your PBX automatically adds an exchange access code to the telephone num-
ber of incoming calls (for example the AUERSWALD PBX) then this will also be
stored in smar-tel-i’s call list. When returning a call from the call list, this code must be
deleted because smar-tel-i automatically executes an exchange access when the
receiver is picked-up. In the case of call screening, you must enter the exchange
access code.
5. 2. 1
Entering Exchange Line Codes
Search for the function under the menu-group
P
HONE
-I
NSTALLATIONS
(refer to page 31).
change
A
Open the menu.
ok
rA
Enter a 4-digit PIN (“0000“ factory default set-
ting) and confirm.
(Inputting Numbers: refer to page 32).
r
Enter the exchange line access code.
ok
A
Store the exchange line access code.
When operating an AUERSWALD PBX, please use the PBX function “Direct
Exchange Device“ (refer to the PBX user manual), wich is easier to use, in place
of the function integrated into the telephone itself.
Ext.Line Code NO
change next
PIN Input: _
ok
Ext.Line Code: _
ok del
Ext.Line Code:
0_
ok del
