B-24
Operator's Manual
Oper
ati
o
n
Setting immediate connection without dialling:
Deactivating immediate connection without dialling:
The ETS-4308 I PBX has an alarm input. If this input's two connections (ALARM and GND)
are connected together, the system issues an alarm (for more details on the switching input,
refer to Chapter Technical Data on page I-82 in the Installation and Configuration Manual).
For more information on alarm sequences and the settings that you need for them in your
PBX, refer to Chapter Activating alarm (ETS-4308 I only) on page I-62 in the Installation and
Configuration Manual. The following section describes how you acknowledge (switch off) an
alarm that has already been triggered.
Acknowledging an alarm from an internal alarm extension:
Acknowledging an alarm from an external alarm extension:
b
7
Q
3
n
Universal password
3 and internal calling number of target telephone (e.g. 33)
or
36
x
36 and the number of the call group (1-8)
or
3
k
3 and number of abbreviated dialling memory
b
7
Q
30
Within 2 seconds
Universal password
h
For immediate connection without dialling to abbreviated dialling number
씮
outgoing
access is necessary.
For general information on programming by telephone and the tones that are issued in
this connection, refer to Page B-5.
1. 31
Acknowledging a triggered alarm (ETS-4308 I only)
c
b
a
Alarm call (special ringing rhythm)
c
b
f
0
a
Alarm call to an
external telephone
Two-tone signal or
recorded announcement
Within 30 seconds (120 with recorded
announcement) using a DTMF tele-
phone or a DTMF generator
