616
COMpact 5200/5200R/5500R - Firmware V7.2 - Advanced Information V04 07/2018
Settings – Abonnés (Abo)
Propriétés / Synthèse des fonctions
Durée du flashing (décrocher-raccrocher)
Hook flash timing enables the PBX to detect a flash signal from the
subscriber in question.
For this to work, the hook flash timing must correspond with the time that is
configured for the flash signal on the analogue end device (see the phone
manual).
Note:
DTMF phones that execute various functions using the T-Net function
key/menu use a flash of 300 ms to do this. In order to also use these
functions on the PBX, the same time as the hook flash timing must be
configured on the PBX. Usually, there is an additional flash button
available on this phone that must also be configured with this value (see
the phone manual).
Note that the PBX does not detect a receiver being hanged up until after
hook flash timing is finished.
Sonnerie pour les appels internes
The ringtone specifies which sequence of sounds is used to signal internal
calls to internal subscribers on the PBX.
Note:
See the Functions, Uses, Concepts > Ring tones section for infor-
mation about exceptions to signalling and sound sequences.
