Configuring Internal IP Telephony
COMpact 5000/R - Firmware V7.4A - Advanced Information V13 06/2019
- 261 -
Configuring Internal IP Telephony
Requirements:
• Internal VoIP channel (optional, see Technical Data in the Instructions)
Proceed as follows:
1. Configure a VoIP channel as an internal VoIP channel for each
planned internal VoIP subscriber.
2. If necessary, configure the Port SIP du registre VoIP interne.
3. Create internal numbers for the VoIP subscribers.
4. If required, change the automatically generated PINs and passwords.
Note:
The user passwords are needed to authenticate the VoIP
phones when they are registered with the PBX.
5. Configure the VoIP end devices. To do this, you need the following
information:
IP address or URL of the PBX
SIP port of the internal VoIP registrar
Internal number of the VoIP subscriber
User password of the VoIP subscriber
Note:
You will find notes about how to configure different VoIP end
devices on the Internet (see
6. Check whether the VoIP subscriber was successfully registered on the
PBX (page Surveillance > Status int. VoIP subscribers).
Summary of Contents for COMpact 5000R
Page 1: ...V13 06 2019 COMpact 5000 R Advanced Information ...
Page 224: ...Tones COMpact 5000 R Firmware V7 4A Advanced Information V13 06 2019 224 ...
Page 1278: ...B COMpact 5000 R Firmware V7 4A Advanced Information V13 06 2019 1278 B B Channel B Channel ...
Page 1385: ...W COMpact 5000 R Firmware V7 4A Advanced Information V13 06 2019 1385 W WAN WAN ...