410
COMpact 5000/R - Firmware V6.6A - Installation, Operation and Configuration V05 03/2016
Functions
Loudspeaker Announcement
Entering DTMF Sequences to Control the Announcement Output
5. In the
Module
and
Port
list fields, select the module and the port to which the device
that can be used as announcement output (e. g. an a/b-Audiobox at a loudspeaker
system) is connected.
6. Click
Save
.
7. Enter a new internal number in the
Phone number
entry field. Possible entries:
Note:
Double allocation of a number is not possible.
Using phone numbers with few digits (two or three-digit numbers) inevitably
restricts the possible supply of phone numbers with more digits. For
example, if the phone number 12 is assigned, the phone numbers 120-129
and 1200-1299 are no longer available.
The default exchange line access number on the PBX is 0 in the factory
settings; however, this can be changed. Note that changing the exchange line
access number restricts the telephone numbering plan.
8. Click
Save
.
9. Click
Close
.
Note:
To create further configurations for an announcement output, open the
page
Devices > Announcement outputs
and click
Configure
in the line of
the corresponding announcement output. The configuration is described in
the following.
Entering DTMF Sequences to Control the Announcement Output
The PBX uses DTMF sequences to control the analogue announcement outputs. For this
purpose, the PBX needs to know which DTMF sequences the connected device requires to
enable or terminate the connection (see the manual of the device in question).
Proceed as follows:
•
Separately for announcement outputs
•
Using the configuration manager
2 to 4 digits in the range of
10
to
9999
