Auerswald COMpact 2206 USB, Installation And Configuration Manual

Page: 10 / 68

10
Technical Data
Analog Subscriber Connection
Usage
COMpact 2206 USB: 8 connections for analog devices
COMpact 4410 USB: 8 connections for analog devices
Connector Type detachable screw clamp connectors (for three subscrib-
ers also TAE-jacks
1
)
Dialling method pulse dial or DTMF
Voltage unloaded max. 40 VDC
Loop current app. 21 mA
Range 2 x 50
액
, app. 800 m at 0,6 mm
얒
Ringer Voltage app. 45 V
eff
, switchable 25 Hz/50 Hz
Dial Tones 425 Hz
앧
5%, Interval
앧
10%
Impedance analog symmetric
Germany, Switzerland, Luxembourg, Denmark: Z
R
Austria and Spain: 600
액
Charge meter pulse switchable, 12 kHz/16 kHz
Internal S
0
Port
Usage 1 S
0
port internal
Connector Type 4-pole detachable screw clamp connectors, additionally
western modular jacks
Connection Type, internal S
0
basic rate connection as Point-to-Multipoint connec-
tion, EURO-ISDN (DSS-1)
Devices, internal 8 ISDN devices maximum, 4 line powered devices maxi-
mum e.g. different ISDN telephones (2 telephones is rec-
ommended)
Range, internal 150 m maximum (for bus wiring, please observe the euro-
pean standards ENV 41001 [DINV 41001] and
EN 28877)
Termination Resistors switchable; default factory settings: on
System Display Connection
Connector Type
detachable screw clamp connector (and TAE-jack)
PC Connection
Serial Interface
RS-232-C, V.24, 9600-57600 Baud (8 bit, no parity,
1 stop bit), no handshake
detachable screw clamp 3-pole connector
USB Interface Full Speed, V 1.1
Music Input/Output
Input Level
adjustable from -18 to +10 dB (1 V
eff
)
Output Level max. 1 V
eff
Impedance 1 k
액
Other Data
Casing
ABS, Cabinet with cover
Size (W x H x D) 301 mm x 243 mm x 86,5 mm
Weight app. 1500 g
Safety EN 60950, CE
COMpact 2S
0
Module
Connection Options
Usage
1 S
0
port internal, 1 S
0
port switchable as internal or
external S
0
port (jumper)
Connector Type 4-pole detachable screw clamp connectors, additionally
western modular jacks
Connection Type, external S
0
basic rate connection as Point-to-Multipoint or Point-
to-Point connection, Euro-ISDN (DSS-1), PBX is self
powered
Connection Type, internal S
0
basic rate connection as Point-to-Multipoint connec-
tion, EURO-ISDN (DSS-1)
Devices, internal 8 ISDN devices maximum, 4 line powered devices maxi-
mum e.g. different ISDN telephones
(2 telephones recommended)
Range, internal 150 m maximum (for bus wiring, please observe the euro-
pean standards ENV 41001 [DINV 41001] and
EN 28877)
Termination Resistors switchable; default factory setting: on
Other Data
Installation
Slot insert in the case of the COMpact 4410 USB
Power Supply from COMpact 4410 USB
Size 92 x 60 x 17 mm
Weight ca. 49 g
Safety EN 60950, CE
COMpact TS Module
Connection Options
Usage
3 Relay outputs, default factory settings: for the door ter-
minals,
2 door key inputs reconfigurable to alarm inputs
Connector Type detachable screw clamp connectors
Interface Door Terminal FTZ-123-D12-0
Power Supply Door Terminal 12 VDC, 100 mA
Relay Contact floating, 30 V/1 A maximum
Door Key Input Voltage configuration dependent 0 V or
5-15 VAC/DC with door key (make contact)
Alarm input voltage Depending on configuration 0 V or 5-15 VAC/DC
via alarm contact (make contact)
Active condition Alarm input Contact closed for more than 0,5 sec
Other
Installation
Slot in the cabinet of COMpact 4410 USB or
COMpact 2206 USB
Power Supply from COMpact 4410 USB or COMpact 2206 USB
Size 92 x 60 x 14 mm
Weight ca. 47 g
Safety EN 60950, CE
Technical changes may be introduced without prior notice
Technical Advice (Power Outage)
If you like to use the PBX during a power outage, you will need an unin-
terruptable power supply, e.g. the USV-500 Sinus (Auerswald acces-
sory).
You can switch a single emergency mode telephone like the system tel-
ephone COMfort 1000 (Auerswald accessory) during a power outage
from the internal to the external S
0
port with the ISDN-Autoswitch (Auer-
swald accessory).
1. Outside of Germany Western modular jacks (Layout on page 25 )