Querying Information from the Handset
Querying the Firmware Versions of the Devices
84
Engl
ish
The display shows the RPN of the currently used transmitter and the measured radio signal
strength (RSSI).
Note:
RPN 0 or 1 stands for a base station, 2-7 were allocated to a repeater upon regist-
ration.
The RSSI can show a value between 0 and about 100.
Querying the Firmware Versions of the Devices
Requirements for querying the base station:
– Base station connected to PBX
– Handset registered with base station
– Handset within range of the base station or a registered repeater
1.
Press the softkey under Menu.
2.
Using your navigation keys, navigate to the Settings option and press the softkey under
OK.
3.
Using your navigation keys (up/down), navigate to the Maintenance setting and press the
softkey under OK.
4.
Using your navigation keys (up/down), navigate to the Software Version setting and press
the softkey under OK.
5.
Using your navigation keys (up/down), navigate to the information you want to query
(Handset or Base Station) and press the softkey under OK.
The corresponding firmware version is shown on the display.
Summary of Contents for COMfortel DECT 900
Page 2: ......
Page 87: ...BOHRSCHABLONEN ...
Page 89: ......
Page 92: ...884279 01 12 10 Der Umwelt zuliebe 100 Altpapier Save the Earth 100 Recycling Paper ...
