Auerswald COMfortel 600, Operation Manual Setup And Operation, Page: 51 / 84

Commissioning
COMfortel 600 - Setup and Operation V01 06/2014
51
This section describes how to connect the telephone. This includes the settings required to
put the telephone into operation on an Auerswald PBX.
Commissioning the Telephone
Requirements
– The connecting cable delivered with the telephone
– Internal telephone number entered in the configuration for the telephone
1.
Insert an RJ-11 plug of the connecting cable into the socket labelled
on the bottom of the telephone.
2.
Guide the cable to the outside using the corresponding cable channel.
3.
Insert the other RJ-11 plug of the connecting cable into an analogue socket
connected to the PBX or provided by the network provider.
Note: Within Germany, use the accompanying TAE-F/RJ-11 adapter.
Further Steps
Configure the telephone according to your requirements. Carry out the con-
figuration using the menu on the telephone display (see section Operation
and Configuration on
page 53 ).
Required Settings for Operating on an Auerswald PBX
The telephone can display the existing information for an incoming call on the
display and save it in the caller list (CLIP). This includes the telephone number
and name of the caller as well as the date and time of the call.
Notes:
A name saved in the PBX (for example, in the short-code memory) is over-
ridden by any corresponding entries in the telephone book on that tele-
phone.
The time saved in the telephone is overwritten by the information generated
by a call.
In order for the telephone to easily detect this information, it needs a defined call
signal that must be enabled for the subscriber when operating an Auerswald
PBX.
Commissioning