Auerswald COMfortel 1500, User Manual

Page: 16 / 236

Introduction
First Use of the Telephone
16
3. Put – if existing – the wall-mount
power supply COMfortel XT-PS
(type number 809) in a freely
accessible 230 V mains socket
(only necessary when operating a
key expansion module COMfortel
Xtension30 with a COMfortel
2500; see
page 17 ).
4. Now the system telephone does a
selftest. The LEDs will flash, the
Auerswald logo and then the
name (e.g. “COMfortel 2500”) as
well as the software version of the
telephone are shown and a data
exchange between the system
telephone and the PBX will follow.
If a system telephone that has been previously attached to another (older) PBX is connected
to a COMpact 5010/5020 VoIP or a COMmander Basic.2/Business (or vice versa), the exist-
ing configuration will be deleted irreversibly and completely – after confirmation of the ques-
tion in the display if a PBX change should be done (see also
page 184 ).
COMfortel 2500: If no wall-mount power supply is needed (no expansion COMfortel
Xtension30 is connected), the bridge plug has to be put into the jack
.
Mandatory Settings
When performing a first time connection to the PBX, the user language and a valid subscriber
(MSN) has not yet been entered into the system telephone. In this case and after a few sec-
onds, you will be asked for these entries in the display.
The internal telephone number entered here has to be entered for the corresponding internal
S
0
- or U
P0
port in the configuration programme of the PBX also. Use each of the internal sub-
scriber telephone numbers for only one ISDN devices connected to your PBX.
Pic. 2: Connection to the PBX
☞
Important
☞
Important
On the display appears the
menu for the language selec-
tion.
Use the and softkeys to browse to the
option you require and press the softkey to
the left of the option:
쮿
[language]: Selects one of the presented
language options as display language.
...
On the display appears the
menu for the MSN entry.