Auerswald COMfortel 1500, User Manual

Page: 129 / 236

Use of the Telephone and PBX System
Announcement/Intercom via System Telephone (InterCom)
129
Outbound InterCom Calls with the System Telephone
For outbound InterCom Calls to other system telephones a key can be assigned on the sys-
tem telephone to simplify the function.
Assign a Key with the Function “InterCom”:
Use the Function “InterCom” via Key (only during the idle State of the Telephone):
By pressing the key the configured internal subscriber is called and the defined mode of the
InterCom call - announcement or handsfree operation - is started. Depending on the defined
mode of switching you have to hold the key during the announcement (as soon as you
release the key again, the call will be disconnected) or switched over by shortly pressing the
key (the key is pressed at the start once and at the end once).
LED Signalling next to the Key “InterCom”:
Open the key programming menu for the func-
tion “InterCom” (You will find help on
page 33
and the following).
define keys
function key ...
... level
InterCom
Use the and softkeys to browse to the
option you require and press the softkey to
the left of the option:
앫
Audio out: (see page 130 ).
앫
IC-OneWay: Assign a key with the function
“InterCom Announcement”.
앫
IC-Speakerphone: Assign a key with the
function “InterCom handsfree operation”.
...
The current settings for the key
assignment is shown on the
display.
If you like to change the current settings, press
the softkey in front of the corresponding
selection once or several times (You will find
help on
page 155 and the following):
앫
[telephone number]: Allows to enter an
internal target number.
앫
[name]: Allows to enter a name for the tar-
get.
앫
[execution type]: Enables the assignment
with hold key and switch over.
Press the softkey to complete the settings.
green Connection to the InterCom target established
off No active connection to the InterCom target