193
COMfortel 1400 IP/2600 IP/3600 IP - Firmware V2.6 - Operation/Configuration - V05 09/2016
Contacts and Phone Number Lists
Contacts
Function Key for Contact
Press the key to display all phone numbers assinged to this contact and to
dial them directly.
In addition, the corresponding LED indicates the status of the function.
Proceed as follows by assigning the function key:
•
Using the Configuration Manager by selecting
Contact
•
Using the telephone by selecting
Contact
Notes:
The function can only be set up on a programmable function key that has
an LED (not on a touch function key).
The function key
Contact
can refer to synchronised contact data. Thus,
when reestablishing a data backup, the main number might not be
assigned explicitly to the contacts. In this case, the function key must be
defined again.
For further information about the general procedures when assigning
function keys, see
Additional settings for this function key are described in the following.
Contact
Select the contact.
LED signalling on the contact key:
green
blinking
The contact called and the call was not accepted.
