Auerswald COMfortel 1100, Operation And Configuration Instructions, Page: 209 / 273

COMfortel 1100 - Firmware Version 4.4 - COMfortel Set V2.7 - Version of the Manual 04 11/10
209
Configuring and Operating Functions
Targeted Exchange Line Access
Configuring and Operating Function Key for Targeted Exchange Line Access (B)
6. In the Key name entry field, enter a name for the key. The following entries are
possible:
Clicking automatically enters the default name in the entry field.
Note: The key name is used for printing the label and for display.
Further steps:
– Save your configuration before closing.
Configuring and Operating Function Key for Targeted Exchange Line Access (B)
Important: Only available for operation on the PBXs COMpact 2204 USB,
COMpact 2206 USB, COMpact 4406 DSL, COMpact 4410 USB and
COMmander Basic.
Press the key to initiate targeted exchange line access. This allows you to immediately dial the
external telephone number (without an exchange line access number).
In addition, when the function is defined on the first key level, the status of the S
0
port is
indicated by the corresponding LED.
The configuration can be carried out as follows:
• Via COMfortel Set
Up to 16 digits
Digits and characters
LED signalling next to the key:
Red Both B-channels on the S
0
port are in use.
Yellow One B-channel on the S
0
port is still available. Press the key to allocate the
line still available.
Off S
0
port is available. Press the key to allocate one of the available lines.