COMfortel 1100 - Firmware Version 4.4 - COMfortel Set V2.7 - Version of the Manual 04 11/10
159
Configuring and Operating Functions
Group Functions
Configuring and Operating the Display of the Group Status
Configuring and Operating the Display of the Group Status
Press the key in the idle mode of the telephone to display the current group status of the
subscribers (logged out, logged in as incoming and/or outgoing) on the LEDs of configured
speed dialling keys for approx. ten seconds. For this purpose, the speed dialling keys must be
assigned to the corresponding subscriber telephone numbers. Press the key again during the
ten seconds to cancel the display.
The configuration can be carried out as follows:
• Via COMfortel Set
Configuring Function Key for Displaying the Group Status via COMfortel Set
Requirements:
– An open configuration and the required PIN, if necessary
1.
Open the page Function keys > Assign function keys.
2.
Click one of the following tabs:
3.
Right-click the function key you want to assign.
A function selection dialogue opens.
LED signalling next to the key:
Blinking
yellow
The group status is being queried.
LED signalling next to the speed dialling keys assigned to subscriber telephone
numbers (group members):
Red
The telephone is logged out of the group.
Green
The telephone is logged into the group for incoming and outgoing calls.
Yellow
The telephone is logged into the group for incoming calls.
Blinking
yellow
The telephone is logged into the group for outgoing calls.
Level 1: Keys are defined on the first key level.
Level 2: Keys are defined on the second key level.
Summary of Contents for COMfortel 1100
Page 273: ...04 11 10...