Auerswald COMfort DECT 800, Installation And Configuration Manual

Page: 13 / 36

Commissioning
13
Login of the Handset to the Base Station
To connect a handset to the base station as described later, the following preconditions have to be
fulfilled first:
The base station has to be connected to the PBX and the battery pack of the handset has to be
connected to the handset and charged (see manual of the handset). The handset has to be within
the range of the base station.
☞
If you like to prepare a configuration with the assignment of internal telephone numbers first, you
can directly enter the serial numbers of the individual handsets into the configuration program COM-
set of the PBX. The following log in procedure must be performed anyway for each handset later.
Start the Log in at the Base Station
Press the gray pushbutton on the bottom at the front side of the base station now until the LED of
the base station flashes alternately in red and green colors. Now you have 60 seconds time to per-
form the following procedure on the handset. If this is not time enough, the pushbutton has to be
pressed again.
Perform the Log in at the Handset
M
Open the main menu.
Auerswald
COMfort DECT