Settings
a/b-Audiobox - Operation Guide - V03 10/2020
19
Requirements:
– Connection has been made to the internal a/b port on a PBX
– An internal telephone number has been set up for the a/b-Audiobox on the
PBX
– Knowledge of the PIN (0000 in the factory settings)
– DTMF-enabled internal telephone or DTMF tone generator
– Programming mode has been initiated (by pressing and holding the pro
-
gramming key for five seconds)
1.
Pick up the receiver of an internal telephone.
2.
Dial the internal telephone number of the a/b-Audiobox.
This establishes the connection.
3.
Dial
*
.
You will hear the confirmation tone (five sequential tones).
Note:
If you only hear a short sound instead of the confirmation tone (after
restarting programming mode), enter the PIN and then dial
*
again.
4.
After the confirmation tone ends, dial one of the following character strings.
711
: Switches on the sound of the gong before the announcement.
710
: Switches off the sound of the gong before the announcement (factory
settings).
You will hear the confirmation tone (five sequential tones).
The a/b-Audiobox continues to be in programming mode. For ad
-
ditional programming actions, begin with the 3rd step.
Setting the Volume
You can use this programming to configure the volume of the connected loud
-
speaker, within certain limits.
Requirements:
– Connection has been made to the internal a/b port on a PBX