background image

128-8190

1 of 8

Model: PRO-9649b

Owner’s Manual

3 Button Remote Security System

with Dual Stage Shock Sensor

IMPORTANT ! 

 In order to provide the highest possible level of security to your vehicle, this

system is equipped with selectable manual override circuitry.  It is possible that you will need
to manually override your security system if the transmitter becomes lost, or inoperative due to
battery failure. Reading the sections on 

"MANUALLY OVERRIDING YOUR SYSTEM"

 is nec-

essary to fully understand the procedure required to enable your vehicle in such situations.
In addition, the chart on the last page of this manual has a section for the particular features
and options installed in your vehicle as well as the override method selected. 

Valet Switch

manual override is pre-selected from the factory,

 however, the system can be config-

ured for "Custom Code" operation.  Confirm the override mode selected on the last page of this
manual, and familiarize yourself with the selection on it's operation.

FEATURES:

Š

2 Three Button Programmable RF Trans-
mitters

Š

Five Channel Receiver
(capable of accepting 4 transmitters)

Š

Code Hopping Technology

Š

Selectable Manual Override Mode

Š

Remote Panic in all modes

Š

Protected Valet

Š

User Programmable Manual Override
Code

Š

7 Function LED - Arm / Disarm / Zone 1
/ Zone 2 / Zone 3 / Valet / Arming

Š

Intrusion Alert with Memory

Š

Audible Arm / Disarm / Defective Zone /
Tamper Confirmation

Š

Instant Siren Activation

Š

Starter Disable

Š

True Last Door Arming (hardwire only)

Š

Defective Zone By-Pass

Š

Hardwire or Voltage Sense Selectable

Š

Active or Passive Arming Selectable

Š

Programmable Auto Lock On / Off

Š

Programmable Auto Unlock On / Off

Š

Programmable Door Lock Pulse Duration 1
Second/3.5 Seconds/1 Sec L/Dbl. U/L

Š

Programmable Active or Passive Door
Locks

Š

User Programmable Permanent Chirp Delete

Š

On Command RF Chirp Delete from Trans-
mitter Or Selectable Through Software

Š

6 Tone Multi Tone Siren (And or)

Š

Car Horn Activation for additional alarm
response

Š

Additional Negative Trigger Input

Š

RF Inhibit with ignition on

Š

Parking Light Flasher

Š

Remote Trunk Release (must have
electronic  trunk release)

Š

Remote Keyless Entry With Optional
Access  Guard (must have power door
locks)

Š

Illuminated Entry

Š

Plug In Dual Stage Shock Sensor

OPTIONS:

Š

 Remote Trunk Release (must have electronic trunk release)

Š

 Remote Keyless Entry (must have power door locks)

Š

 Multiple Vehicle Capable

Š

 Remote Starter

Š

 Remote Power Window Roll Up

Š

 Remote Garage Door Interface

Š

 Headlight Illumination During Arming/Disarming, Or Both

Summary of Contents for Pursuit PRO-9649b









Reviews: